HP CM6030 Service Manual - Page 531

Table 7-4 Control-panel messages (continued) Control panel message Description 66.12.34 Output accessory failure An output accessory is not functioning properly. Recommended action ● Verify that intermediate connector J1040 and J721 on the stacker controller PCA are fully seated and not damaged. Check the wiring at the sensor. ● If the error persist, replace sensor PI48. ● If the error persist, replace the output-bin-2 assembly. See Output-bin 2 on page 801. NOTE: The output-bin-2 assembly includes the output-bin-2-shift motor (M38), output-bin-2 area sensors, and the output-bin-2 driver PCA. 2. If output bin 2 does not move during the test, perform the following steps. ◦ Check the output-bin tracks for damage. ◦ Replace the output-bin-2 assembly. See Output-bin 2 on page 801. NOTE: The output-bin-2 assembly includes the outputbin-2-shift motor (M38), outputbin-2 area sensors, and the outputbin-2 driver PCA. ◦ Only if the error persists and none of the previous steps correct the problem, replace the stacker controller PCA. See Stacker controller PCA on page 828. 1. Turn the product off. 2. Verify that all output accessories are securely connected. 3. If the product uses cables, disconnect and reconnect them. ENWW Control-panel messages 485