HP CM6030 Service Manual - Page 502

Table 7-4 Control-panel messages (continued) Control panel message Description Recommended action expected after sensing the arrival of the new booklet from the folding rollers. Also occurs when the vertical-paper-path sensor (PI17) remains activated longer than 3. expected after the paper has already passed through the folding rollers and is now detected by the booklet-delivery sensor 4. (PI11). before starting the test and make sure that the folding rollers are rotating when motor M2 is on. Check sensor PI11 and PI17 for damage. Make sure that the sensors are not obstructed. 13.13 Paper Stop Jam In Duplex Area Sensors G - H 5. Make sure that sensor PI11 and sensor PI17 are securely fastened to the chassis. The duplex refeed paper stopped between Follow the onscreen instructions to locate the switchback sensor (G) and the duplexer- and remove the paper or obstruction. delivery sensor (H). See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.1C Fuser Wrap Jam, Paper in Fuser The paper is wrapping at the fuser. Follow the onscreen instructions to locate and remove the paper or obstruction. 13.20 Paper Eject Jam at Sensors E, F - G The paper stopped at either the loop sensor Follow the onscreen instructions to locate (E), the fuser-output sensor (F) or the and remove the paper or obstruction. switchback sensor (G). See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.21 Door Open Jam The paper position is unknown. See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. Follow the onscreen instructions to locate and remove the paper or obstruction. 13.2B Paper Stop Jam In Output Accessory Bridge The paper stopped before reaching IPTU sensor 1 (K). Follow the onscreen instructions to locate and remove the paper or obstruction. See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.2C Paper Late Jam in Output Accessory Bridge (1) The paper stopped between IPTU sensor 1 Follow the onscreen instructions to locate (K) and IPTU sensor 3 (M). and remove the paper or obstruction. See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.2D Paper Late Jam in Output Accessory Bridge (2) The paper stopped in the path along IPTU sensor 1 (K), IPTU sensor 2 (L), and IPTU sensor 3 (M). Follow the onscreen instructions to locate and remove the paper or obstruction. See Figure 7-4 Paper-path sensors on page 511 to determine the location of the sensor originating the failure. 13.2E Paper Late Jam Near Fuser at Sensors F - J The paper stopped between the fuser-output Follow the onscreen instructions to locate sensor (F) and the output-bin-full sensor (J). and remove the paper or obstruction. 456 Chapter 7 Solve problems ENWW