HP CM6030 Service Manual - Page 542

Table 7-4 Control-panel messages (continued) Control panel message Description Recommended action Bad duplexer connection To continue turn The duplex printing accessory is not off then on connected correctly to the product. 1. Reconnect the connectors for the duplexing driver PCA (J4101), intermediate (J1902), and the DC controller PCA (J133). 2. Replace the duplexing reverse unit. See Duplexing reverse unit on page 323. Bad optional tray connection The optional tray is not connected properly 1. and must be reconnected before printing can continue. 2. Turn the product off. Remove and then reinstall optional tray or trays. 3. Reinstall the IPTU. See IPTU on page 736. 4. Reconnect the connectors for the IPTU driver PCA (J7001) and the DC controller PCA (J130). 5. Replace the IPTU driver PCA. See IPTU driver PCA on page 754. Calibrating The product is calibrating. No action is necessary. Cancelling The product is canceling a job. No action is necessary. Card Slot Device Failure - To Clear Touch The specified device failed. OK Touch OK to clear. Card Slot file operation failed To clear touch OK A PJL file system command was received that attempted to perform an illogical operation, such as downloading a file to a non-existent directory. Touch OK to clear. Card Slot is write protected To clear touch The device is protected and no new files can Touch OK to clear message. OK be written to it. Card Slot Not Initialized The file system device must be initialized before it can be used. Initialize the device. Cartridge Error - Replace Black Cartridge Toner has settled in the black print cartridge Replace the black cartridge. After replacing and the auger cannot turn. the cartridge, turn the power off and then on to continue Cartridge Error-Replace color cartridges The cyan, magenta, or yellow print cartridges Replace the defective print cartridges and Reinstall, then turn off and then on are defective and need to be replaced. turn the product off and then on. Checking engine The product is checking the engine. No action is necessary. Checking paper path The engine is checking the rollers for possible No action is necessary. paper jams. Chosen personality not available. To continue touch OK. A print job requested a product language (personality) that is not available for this product. The job will not print and will be cleared from memory. Print the job by using a printer driver for a different printer language, or add the requested language to the product (if possible). To see a list of available personalities, print a configuration page. (See Information pages on page 90.) Cleaning The cleaning page is being processed. No action is necessary. Cleaning disk % complete Do not power off A storage device is being sanitized or cleaned. Do not turn off the product. The product's functions are unavailable. The product will automatically restart when finished. 496 Chapter 7 Solve problems ENWW