HP ENVY 13-ah1000 Maintenance and Service Guide - Page 38
Solid-state drive, Remove the Phillips M2.0×3.2 screw
View all HP ENVY 13-ah1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Solid-state drive Description 1-TB, 2280, PCIe, NVMe, SS solid-state drive with TLC 512-GB, M.2 2280, PCIe, NVMe, SS solid-state drive with TLC 512-GB, 2280, PCIe, NVMe solid-state drive 360-GB, 2280, PCIe, NVMe solid-state drive with TLC (Asia Pacific Japan only) 256-GB, 2280, PCIe, NVMe solid-state drive 256-GB, M.2 2280, PCIe, NVMe, SS solid-state drive with TLC 128-GB, M.2 2280-SATA3, SS solid-state drive with TLC Spare part number L19503-001 L19507-001 L19508-001 L19506-001 L19505-001 L19504-001 L19502-001 Before removing the solid-state drive, follow these steps: 1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and then unplugging the AC adapter from the computer. 4. Remove the bottom cover (see Bottom cover on page 26). 5. Disconnect the battery cable from the system board (see Battery on page 28). Remove the solid-state drive: 1. Remove the Phillips M2.0×3.2 screw (1) that secures the solid-state drive to the system board. 2. Remove the solid-state drive (2) by pulling it away from the connector. NOTE: Solid-state drives are designed with notches to prevent incorrect insertion. Reverse this procedure to install the solid-state drive. 30 Chapter 5 Removal and replacement procedures