HP ENVY 13-ah1000 Maintenance and Service Guide - Page 55

that secure the display hinges to the keyboard/top cover

Get HP ENVY 13-ah1000 PDF manuals and user guides View all HP ENVY 13-ah1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 55 highlights

3. Release the display webcam/microphone cable from the retention clips (3) and routing channels built into the keyboard/top cover. 4. Release the adhesive strip (4) that secures the display panel cable to the system board. 5. Release the ZIF connector (5) to which display panel cable is connected, and then disconnect the display panel cable cable from the system board. 6. Release the display panel cable from the retention clips (6) and routing channels built into the keyboard/ top cover. 7. Remove the three Phillips M2.5×6.7 screws (1) that secure the display hinges to the keyboard/top cover. 8. Swing the display hinges (2) up and back. 9. Lift the front edge of the keyboard/top cover (1) until it rests at an angle. Component replacement procedures 47

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
3.
Release the display webcam/microphone cable from the retention clips
(3)
and routing channels built
into the keyboard/top cover.
4.
Release the adhesive strip
(4)
that secures the display panel cable to the system board.
5.
Release the ZIF connector
(5)
to which display panel cable is connected, and then disconnect the display
panel cable cable from the system board.
6.
Release the display panel cable from the retention clips
(6)
and routing channels built into the keyboard/
top cover.
7.
Remove the three Phillips M2.5×6.7 screws
(1)
that secure the display hinges to the keyboard/top cover.
8.
Swing the display hinges
(2)
up and back.
9.
Lift the front edge of the keyboard/top cover
(1)
until it rests at an angle.
Component replacement procedures
47