HP ENVY 13-aq1000 Maintenance and Service Guide - Page 43

UMA graphics, Remove the four Phillips M2.0 × 3.0 screws

Get HP ENVY 13-aq1000 PDF manuals and user guides View all HP ENVY 13-aq1000 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 43 highlights

3. Clean and reapply thermal material from the surfaces of the system board components (1) (3) and the heat sink (2) (4) each time the heat sink is removed. Remove the heat sink on models with UMA graphics:: 1. Remove the conductive tape from the memory cover and the top of the heat sink (1). You do not have to remove the tape from both covers to remove the heat sink. 2. Remove the four Phillips M2.0 × 3.0 screws (2) that secure the heat sink, and then remove the heat sink from the system board (3). Component replacement procedures 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
3.
Clean and reapply thermal material from the surfaces of the system board components
(1) (3)
and the
heat sink
(2) (4)
each time the heat sink is removed.
Remove the heat sink on models with
UMA graphics:
:
1.
Remove the conductive tape from the memory cover and the top of the heat sink
(1)
. You do not have to
remove the tape from both covers to remove the heat sink.
2.
Remove the four Phillips M2.0 × 3.0 screws
(2)
that secure the heat sink, and then remove the heat sink
from the system board
(3)
.
Component replacement procedures
35