HP ENVY dv7-7227cl HP ENVY dv7 Notebook PC Maintenance and Service Guide IMPOR - Page 81
USB board
View all HP ENVY dv7-7227cl manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
c. Keyboard (see Keyboard on page 59) d. Top cover (see Top cover on page 63) Remove the solid-state drive: 1. Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the system board. (The solid-state drive tilts up.) 2. Remove the solid-state drive by pulling the drive away from the slot at an angle (2). NOTE: The solid-state drive is designed with a notch to prevent incorrect installation into the solid-state drive slot. Reverse this procedure to install the solid-state drive. USB board Description USB board (includes cable) Spare part number 681986-001 Before removing the USB board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. Component replacement procedures 73