HP ENVY m4-1100 HP ENVY m4 Notebook PC Maintenance and Service Guide - Page 65
Remove the Phillips PM2.0×3.5 screw, Remove the fan/heat sink assembly
View all HP ENVY m4-1100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Remove the fan/heat sink assembly: 1. Turn the system board upside down, with the front toward you. 2. Disconnect the fan cable (1) from the system board. 3. Remove the Phillips PM2.0×3.5 screw (2) that secures the fan/heat sink assembly to the system board. 4. Following the 1, 2, 3, 4 sequence stamped into the fan/heat sink assembly, loosen the four captive Phillips screws (3) that secure the fan/heat sink assembly to the system board. Component replacement procedures 57
Remove the fan/heat sink assembly:
1.
Turn the system board upside down, with the front toward you.
2.
Disconnect the fan cable
(1)
from the system board.
3.
Remove the Phillips PM2.0×3.5 screw
(2)
that secures the fan/heat sink assembly to the
system board.
4.
Following the 1, 2, 3, 4 sequence stamped into the fan/heat sink assembly, loosen the four
captive Phillips screws
(3)
that secure the fan/heat sink assembly to the system board.
Component replacement procedures
57