HP Fortis x360 11 inch G5 Chromebook Maintenance and Service Guide Fortis x360 - Page 40

USB board

Get HP Fortis x360 11 inch G5 Chromebook PDF manuals and user guides View all HP Fortis x360 11 inch G5 Chromebook manuals
Add to My Manuals
Save this manual to your list of manuals

Page 40 highlights

1. Prepare the computer for disassembly (Preparation for disassembly on page 28). 2. Remove the bottom cover (see Bottom cover on page 28). 3. Disconnect the battery cable from the system board (see Battery on page 29). Remove the WWAN module: 1. Remove the Phillips M2.0 × 3.0 screw (1) that secures from the bracket on the WWAN module, and then remove the bracket (2). 2. Disconnect the antenna cables (3) from the terminals on the WWAN module. 3. Remove the WWAN module (4) by pulling the module away from the slot at an angle. 4. If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve must be installed on the antenna connector, as shown in the following illustration. To install the WWAN module, reverse this procedure. USB board To remove the USB board, use these procedures and illustrations. USB board 35

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
1.
Prepare the computer for disassembly (
Preparation for disassembly
on page
28
).
2.
Remove the bottom cover (see
Bottom cover
on page
28
).
3.
Disconnect the battery cable from the system board (see
Battery
on page
29
).
Remove the WWAN module:
1.
Remove the Phillips M2.0 × 3.0 screw
(1)
that secures from the bracket on the WWAN module, and
then remove the bracket
(2)
.
2.
Disconnect the antenna cables
(3)
from the terminals on the WWAN module.
3.
Remove the WWAN module
(4)
by pulling the module away from the slot at an angle.
4.
If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve
must be installed on the antenna connector, as shown in the following illustration.
To install the WWAN module, reverse this procedure.
USB board
To remove the USB board, use these procedures and illustrations.
USB board
35