HP Indigo W7250 ITM Bearings Alignment - Page 17
HP Indigo W7250 Manual
![]() |
View all HP Indigo W7250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
f. Pull out the front locking ring (flange) and ITM bearing locking tool. Clean the front locking ring (flange) with IPA and put it in a safe place for later use. Figure 5-6 Front locking ring removed g. Remove the drum rotation stopper. h. Remove the four screws that attach the front bearing to the press wall. See Figure 5-13 4 M6x20 screws on page 19. i. Place spacers between the ITM drum and the rear press wall. You can take a 300 gsm paper and fold it to a thickness of 3 mm, and use it as a spacer. Figure 5-7 Spacer Extracting the ITM bearings 15
![](/manual_guide/products/hewlettpackard-indigo-ws6000-itm-bearings-alignment-df6479e/17.png)
f.
Pull out the front locking ring (flange) and ITM bearing locking tool. Clean the front locking ring
(flange) with IPA and put it in a safe place for later use.
Figure 5-6
Front locking ring removed
g.
Remove the drum rotation stopper.
h.
Remove the four screws that attach the front bearing to the press wall. See
Figure 5-13
4 M6x20
screws
on page
19
.
i.
Place spacers between the ITM drum and the rear press wall. You can take a 300 gsm paper and fold
it to a thickness of 3 mm, and use it as a spacer.
Figure 5-7
Spacer
Extracting the ITM bearings
15