HP Indigo W7250 ITM Bearings Alignment - Page 36

Extract the front bearing by 1 cm.

Page 36 highlights

8. From the zero point, use a regular wrench to close the locking ring according to the angle marked on the bearing cover (+/- 3°). Figure 5-35 Figure Angle marked on bearing cover 9. If the number is less than 29, then use the following conversion table to convert the number to a different angle of closure. 10. If you cannot reach the desired angledo the following: a. Unlock the front locking ring. Do not open the cover screws. b. Extract the front bearing by 1 cm. c. Reinstall the bearing. d. Reinstall the front locking ring. 34 Chapter 5 Aligning the ITM bearings

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42

8.
From the zero point, use a regular wrench to close the locking ring according to the angle marked on the
bearing cover (+/- 3°).
Figure 5-35
Figure Angle marked on bearing cover
9.
If the number is less than 29, then use the following conversion table to convert the number to a
different angle of closure.
10.
If you cannot reach the desired angledo the following:
a.
Unlock the front locking ring.
Do not open the cover screws.
b.
Extract the front bearing by 1 cm.
c.
Reinstall the bearing.
d.
Reinstall the front locking ring.
34
Chapter 5
Aligning the ITM bearings