HP Indigo W7250 ITM Bearings Alignment - Page 26

Closing the ITM bearings cover screws,

Get HP Indigo W7250 PDF manuals and user guides View all HP Indigo W7250 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

14. Install the rear and front caps, on the rear and front chucks, using 3 M4 screws that go into the ITM lamps holder threads. Figure 5-21 Installing the caps on rear and front chucks NOTE: Until this stage, the front and rear ITM bearing cover screws are supposed to be loose. Closing the ITM bearings cover screws Follow these steps to close the ITM bearings cover screws. 1. Attach Allen 5 mm bit to the torqueYou might also need to attach a moment lever due to the high torque closure. Figure 5-22 Setting the torque 24 Chapter 5 Aligning the ITM bearings

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
14.
Install the rear and front caps, on the rear and front chucks, using 3 M4 screws that go into the ITM
lamps holder threads.
Figure 5-21
Installing the caps on rear and front chucks
NOTE:
Until this stage, the front and rear ITM bearing cover screws are supposed to be loose.
Closing the ITM bearings cover screws
Follow these steps to close the ITM bearings cover screws.
1.
Attach Allen 5 mm bit to the torqueYou might also need to attach a moment lever due to the high torque
closure.
Figure 5-22
Setting the torque
24
Chapter 5
Aligning the ITM bearings