HP Indigo W7250 ITM Bearings Alignment - Page 18
HP Indigo W7250 Manual
![]() |
View all HP Indigo W7250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
j. Use the extraction screws to extract the rear bearing from the press wall by 10 - 15 mm. Do not completely remove the bearing. See figure below. 3. At the press rear, remove the locking ring (flange) by removing the (a) 8 screws (12 screws for new ITM drum)You may need to release the (b) 3 bearing cover screws to pull the flange out of the press. Figure 5-8 Rear ITM bearing cover screws 16 Chapter 5 Aligning the ITM bearings
![](/manual_guide/products/hewlettpackard-indigo-ws6000-itm-bearings-alignment-df6479e/18.png)
j.
Use the extraction screws to extract the rear bearing from the press wall by 10 - 15 mm. Do not
completely remove the bearing. See figure below.
3.
At the press rear, remove the locking ring (flange) by removing the (a) 8 screws (12 screws for new ITM
drum)You may need to release the (b) 3 bearing cover screws to pull the flange out of the press.
Figure 5-8
Rear ITM bearing cover screws
16
Chapter 5
Aligning the ITM bearings