HP Indigo W7250 Strain Gauge Second Transfer Measurement Service and Troublesh - Page 11

Value on arm, Measurement output, Related Systab parameters

Get HP Indigo W7250 PDF manuals and user guides View all HP Indigo W7250 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 11 highlights

Figure 2-11 Value on arm Typical measurement output from one of the two strain gauges is shown below. Figure 2-12 Measurement output Related Systab parameters Direction MCN>PLC MCN>PLC PLC>MCN PLC>MCN MCN>PLC MCN>PLC Systab WHS_W_Host_To_PLC:SecoundTransferMesurmentEnable = 0 WHS_W_Host_To_PLC:SecoundTransferMeasurmentMode = 0 I/O: SecoundTransferForceFront IO: SecoundTransferForceRear WHS_W_Configuration: SecoundTrsf_Newton_per_10V_Front = 6300 (default) WHS_W_Configuration: SecoundTrsf_Newton_per_10V_Rear = 6300 (default) Each strain gauge arm should have its own "SecoundTrsf_Newton" value according to the label on the actual strain gauge arm Principles of Operation 9

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
Figure 2-11
Value on arm
Typical measurement output from one of the two strain gauges is shown below.
Figure 2-12
Measurement output
Related Systab parameters
Direction
Systab
MCN>PLC
WHS_W_Host_To_PLC:SecoundTransferMesurmentEnable = 0
MCN>PLC
WHS_W_Host_To_PLC:SecoundTransferMeasurmentMode = 0
PLC>MCN
I/O: SecoundTransferForceFront
PLC>MCN
IO: SecoundTransferForceRear
MCN>PLC
WHS_W_Configuration: SecoundTrsf_Newton_per_10V_Front = 6300 (default)
MCN>PLC
WHS_W_Configuration: SecoundTrsf_Newton_per_10V_Rear = 6300 (default)
Each strain gauge arm should have its own “SecoundTrsf_Newton” value according to the label on the
actual strain gauge arm
Principles of Operation
9