HP Indigo W7250 Strain Gauge Second Transfer Measurement Service and Troublesh - Page 14
Changing the strain gauge Systab values, WHS_W_Configuration: 2ndtrsf_Newton_per_10V_Rear
View all HP Indigo W7250 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Figure 2-16 Torque bushing - Danger zones Changing the strain gauge Systab values Follow these steps to change the strain gauge systab values. Details for inserting the Arm calibration values in Systab: 1. Upload arms parameter (A) into the Systab. ● WHS_W_Configuration: 2ndtrsf_Newton_per_10V_Front ● WHS_W_Configuration: 2ndtrsf_Newton_per_10V_Rear 2. Enter values from the Arm datasheet into the Systab parameters. 12 Chapter 2 Introduction
Figure 2-16
Torque bushing — Danger zones
Changing the strain gauge Systab values
Follow these steps to change the strain gauge systab values.
Details for inserting the Arm calibration values in Systab:
1.
Upload arms parameter (A) into the Systab.
●
WHS_W_Configuration: 2ndtrsf_Newton_per_10V_Front
●
WHS_W_Configuration: 2ndtrsf_Newton_per_10V_Rear
2.
Enter values from the Arm datasheet into the Systab parameters.
12
Chapter 2
Introduction