HP Integrity BLc7000 HP 10GbE Pass-Thru Module User Guide - Page 16

12. Press the Enter key. The module console begins to print C characters until the Xmodem transfer begins. 13. Press Ctrl + Shift + _. The following message appears: Command: D)isconnect, C)hange settings, send B)reak, E)xit command mode X)modem send > 14. Enter x. The following message appears: Xmodem Send: Send a file to the interconnect module using the xmodem transfer protocol. The file can be downloaded to the OA from an HTTP(S), FTP, or TFTP server. After the file has been downloaded, the OA will transfer it to the switch. Please enter the URL below. 15. Enter the transfer URL (tftp://tftpServerIPAddress/10GPTHRU-1.0.7.0_FW.bin). The following message appears: Downloading file ... successful (transferred 210216 bytes) Continue with transfer (yes/no)? 16. Enter y. The following message appears: Starting transfer. Press '_' (Control + Shift + Underscore) to cancel. Note: The transfer will terminate after 30 seconds of inactivity. .......... The pass-thru module displays multiple lines of . characters until the entire firmware transfer is complete. The following message appears: Transfer complete. Welcome to the HP 10GbE Pass-Thru Module Running image 1.0.7.0 Initializing ports [10Gb Pass-Thru Menu] system - System Menu port - Port Menu global - Global Commands Menu 10Gb Pass-Thru# Port 1 is ENABLED Port 2 is ENABLED Port 3 is ENABLED Port 5 is ENABLED Port 6 is ENABLED Port 7 is ENABLED Port 8 is ENABLED Port 9 is ENABLED Port 10 is ENABLED Port 11 is ENABLED Port 12 is ENABLED Updating the 10GbE pass-thru firmware 16