HP Integrity rx5670 Hardware Installation Guide - HP Integrity rx5670 (A6837B/ - Page 16

Installing Hot Swap Power Supplies, Power Supply Load Order,

Get HP Integrity rx5670 PDF manuals and user guides View all HP Integrity rx5670 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 16 highlights

Installing Additional Components Installing Power Supplies and Disk Drives 1. Grasp the handle located at the right edge of the front bezel and pull out. The front bezel will swing away from the chassis. Figure 2-1 hp Integrity rx5670 (front view) ever011 Installing Hot Swap Power Supplies Power Supply Load Order There is no specific load order requirement for hot swap power supplies. However, the supported configuration of an hp Integrity rx5670 requires a minimum of two supplies be installed. A third, optional hot swap power supply may be installed to provide N+1 capability. The right side hot swap power supply is identified as P0, the center hot swap power supply is identified as P1, and the left hot swap power supply is identified as P2. Each hot swap power supply requires a separate power cord be installed in the appropriate power cord receptacle located at the rear of the chassis. Installing a Hot Swap Power Supply To install a hot swap power supply, perform the following steps: WARNING Be careful when installing a hot swap power supply. It is heavier than it appears. 16 Chapter 2

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
Chapter 2
Installing Additional Components
Installing Power Supplies and Disk Drives
16
1. Grasp the handle located at the right edge of the front bezel and pull out. The front bezel will swing away
from the chassis.
Figure 2-1
hp Integrity rx5670 (front view)
Installing Hot Swap Power Supplies
Power Supply Load Order
There is no specific load order requirement for hot swap power supplies. However, the supported
configuration of an hp Integrity rx5670 requires a minimum of two supplies be installed. A third, optional hot
swap power supply may be installed to provide N+1 capability.
The right side hot swap power supply is identified as P0, the center hot swap power supply is identified as P1,
and the left hot swap power supply is identified as P2. Each hot swap power supply requires a separate power
cord be installed in the appropriate power cord receptacle located at the rear of the chassis.
Installing a Hot Swap Power Supply
To install a hot swap power supply, perform the following steps:
WARNING
Be careful when installing a hot swap power supply. It is heavier than it appears.
ever011