HP Integrity rx5670 Hardware Installation Guide - HP Integrity rx5670 (A6837B/ - Page 40

Troubleshooting hp Integrity rx5670 LED Indicators The power LED should be lit while the server is operating. The remote LED will be on when remote access to the MP/SCSI card is enabled. Table 3-1 describes the power, run, attention, and fault LED states, and provides information to help interpret the display to determine server status. Table 3-1 Front Panel Status LED Definitions Power (Green) Run (Green) Attention (Yellow) Fault (Red) Definition off flashing on on on on on on x x on flashing x x off x x x x flashing x off on on off on flashing off on off off on flashing off on off off on on off on flashing off on off flashing x x x x x on or flashing off off off on on flashing flashing flashing off Power is off. Check switches and cables Power is available, but not on. Press (on) front panel power switch Power is on OS is running System is running (non-OS code) Non-critical operator intervention needed Fault condition Standby or total system failure. If failure and more than 1 CPU module is installed, suspect system board. If failure and only 1 CPU module is installed, suspect CPU module or system board. System normal operation. OS running. If the expected OS prompt is not displayed, check console logs. System running (non-OS code). Check console and SL logs for additional data. Can't boot. Boot or system failure. Check console and SL logs for additional information. If failure and more than 1 CPU module is installed, suspect system board. If failure and only 1 CPU module is installed, suspect CPU module or system board. Boot failed. System running (non-OS code). Check console log for additional information. Unexpected reboot attempted. Check console logs. Unexpected reboot/system recovered. Check console logs. Unexpected reboot/system recovering. OS not running. Non-critical operator intervention needed. Check console logs. 40 Chapter 3