HP Jet Fusion 300 User Guide - Page 142
Loosen the two thumb screws at each end of the printhead until the printhead is released.
View all HP Jet Fusion 300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
13. Use a screwdriver to loosen the six screws to remove the cover from the carriage, and carefully set aside the carriage cover. 14. Release both clips, and lift the print-bar cover over the carriage. It will magnetically stay in place. 15. Loosen the two thumb screws at each end of the printhead until the printhead is released. NOTE: Loosen only the screws of the printhead you intend to remove. 136 Chapter 15 Maintenance
13.
Use a screwdriver to loosen the six screws to remove the cover from the carriage, and carefully set aside
the carriage cover.
14.
Release both clips, and lift the print-bar cover over the carriage. It will magnetically stay in place.
15.
Loosen the two thumb screws at each end of the printhead until the printhead is released.
NOTE:
Loosen only the screws of the printhead you intend to remove.
136
Chapter 15
Maintenance