HP Kayak XA 05xx HP Kayak XA Series 05xx, Accessories Installation Guide For M - Page 16

HP Kayak XA 05xx PC Workstation - Installing Accessories In Your HP Minitower PC Workstation Installing Mass Storage Devices 10 Connect the data and power cables to the rear of the device. (The connectors are shaped to go in one way only.) Data Cable When a New SCSI Hard Disk Drive Is Installed Power Cable 11 If you are installing a SCSI device, pass the SCSI cable through the base of the SCSI holder. You will need to remove then replace the SCSI holder to do this. 12 Slide the power supply back into position, and tighten the four selfretaining screws (see page 6). 13 Replace the HP UltraFlow airflow guide and reconnect the fan to the system board (see the illustration on page 5). 14 Install any other accessories before replacing the cover and completing the installation. 15 Follow the instructions below to complete the installation. Completing the Installation of a Hard Disk Drive 1 Switch on the computer. 2 To ensure compatibility, use the FDISK utility to delete any partitions on the new hard disk. 3 Re-boot the computer. Refer to the operating system documentation for information on formatting a drive. 16 English