HP Kayak XA 05xx HP Kayak XA Series 05xx, Accessories Installation Guide For M - Page 20
When an IDE CD-ROM, Drive Is Installed, When a Flexible Disk, Completing the Installation of a Drive
![]() |
View all HP Kayak XA 05xx manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
HP Kayak XA 05xx PC Workstation - Installing Accessories In Your HP Minitower PC Workstation Installing Mass Storage Devices 10 Slide the power supply back into position, and tighten the four selfretaining screws (see page 6). 11 Remove the plastic panel from the cover by pulling the panel from the left and unhinging its right-hand side. Store the panel in a safe place. Unclip and lift out the plastic panel 12 Install any other accessories before replacing the cover and completing the installation. Completing the Installation of a Drive When an IDE CD-ROM Drive Is Installed 1 Switch on the computer and press F2 when F2 Setup appears. 2 In the Setup program, select the Advanced menu, then the IDE Devices submenu. Check that the CD-ROM drive has been detected on the IDE channel. 3 Press F3 to save and exit the program. When a Flexible Disk Drive Is Installed 1 Switch on the computer and press F2 when F2 Setup appears. 2 In the Setup program, select the Advanced menu, then the Flexible Disk Drives submenu, and check that the drive has been detected. 3 Press F3 to save and exit the program. 20 English
![](/manual_guide/products/hewlettpackard-kayak-xa-05xx-hp-kayak-xa-series-05xx-accessories-installation-guide-minitower-models-fddac43/20.png)