HP Kayak XU700 Installing Your Multimedia Sound Kit - 5966-8210 - Page 14

1 Installing Your Multimedia Sound Kit Installing the Accessory Software under Windows NT 4.0 Installing the Accessory Software under Windows NT 4.0 If your system runs Windows NT 4.0, you need to install the accessory software as described here. Installing the CD-ROM Driver Windows NT™ 4.0 automatically detects the CD-ROM drive and loads the required software driver when you switch on your PC. Installing the Sound Board Drivers To install the sound board drivers, complete the following steps. 1 With Windows NT running, insert the HP Multimedia Sound CD in the CD-ROM drive. (Insert the CD label side up; press the open/close pushbutton to open and close the drawer.) 2 Click on the Start button, point to Settings, then click on Control Panel. 3 Double-click on the Add/Remove Programs icon . 4 Click on the Install... button, and then the Next button. 5 Type d:\winnt\setup and then click on the Finish button. Follow the instructions that appear on the screen. (The CD-ROM drive may be your E drive. In this case you would enter e:\winnt\setup. You can check by clicking the Browse button in the Run Installation Program dialog box, and then browsing to the CD-ROM drive.) 6 When the driver has been installed, you see the 16-bit Audio Board Setup window. 7 Click on the OK button. 8 Restart the computer. 6 English