HP LH4r HP Netserver 10/100TX PCI LAN Adapter Guide - Page 6
If the Adapter Can't Connect to the Network
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
Contents Setting Full Duplex in Windows NT/2000 24 Setting Full Duplex in NetWare Servers 24 Setting Full Duplex in Other Operating Systems 25 Join a Virtual LAN 25 General Configuration Notes 26 Adding a VLAN in Windows NT 4.0 26 Adding a VLAN in Windows 2000 27 8 Choosing Adapter Teaming Options 29 General Configuration Notes 29 Setting up Adapter Fault Tolerance 30 Setting up Adapter Fault Tolerance in Windows NT 4.0 ...... 30 Configuring Properties 31 Deleting a Team 31 Setting up Adapter Fault Tolerance in NetWare 31 Deleting a Team 33 Setting up Adaptive Load Balancing 33 Setting up ALB in Windows NT 4.0 34 Deleting a Team 34 Setting up ALB in NetWare 34 Setting Up Cisco Fast EtherChannel 35 Setting up FEC in Windows NT 4.0 35 Setting up FEC in NetWare 36 Teaming Options Supported by OS and Protocol 36 9 Troubleshooting and FAQs 37 If the Adapter Can't Connect to the Network 37 Make sure the cable is installed properly 37 Check the LED lights on the adapter 37 Responder Testing on the Network (Optional 37 Make sure you're using the correct drivers 39 Make sure the switch port and the adapter have the same duplex setting 39 Testing the Adapter (Diagnostics 39 Frequently Asked Questions (FAQs 39 10Technical Information 41 PCI Installation Tips 41 Removing an Existing Adapter in Windows 2000 42 vi