HP LH4r HP Netserver LC 2000 Compaq Rack Install Guide - Page 18
See
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Chapter 3 Rack-Mounting the HP NetServer 1. Use the marking pen to mark the 2nd and 14th holes on both front columns, as shown on the template. See Figure 3-2. NOTE The two column adapters are mounted at the 2nd and 14th holes on the respective front column and provide the captive nuts for mounting the rack slides to the front columns at 7th and 9th holes from the bottom. If you don't have the template, Figure 3-2 shows the location on the front columns for the column adapters. "#" represents the EIA unit numbers on the rack columns. 14th Hole From Bottom # # # # # Bottom of Compaq Rack 2nd Hole From Bottom Figure 3-2. Location Marks on the Rack's Front Columns 2. Mount cage nuts (at 7th and 9th holes) on the left-rear and right-rear rack columns. See Figure 3-3. Push In, then Down, and then Up Rack Nut from the Front Of the Rack Column Figure 3-3. Placing Cage Nuts on Rack Columns Figure 3-4 shows cage nut placement for the two rear rack columns. 14