HP LH4r HP Netserver LC 2000 Compaq Rack Install Guide - Page 5
Introduction
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
1 Introduction This document describes how to mount an HP NetServer LC 2000 into a Compaq® model 4000- or 7000-series rack. Refer to the HP NetServer LC 2000 Installation Guide that came with the NetServer for instructions on adding accessories to, and configuring the NetServer. HP NetServer - Compaq Rack Precautions CAUTION If this NetServer is not installed according to these instructions, damage to the NetServer or accessories may result. Damage due to improper installation is not covered by the HP Warranty. Observe the precautions listed in this section to maintain the NetServer's reliability. When installing this HP NetServer in a Compaq rack enclosure, certain requirements must be addressed to assure that the needs of the NetServer are met. This NetServer will meet the requirements designed for the NetServer if: • The NetServer is installed in a Compaq model 4000- or 7000-series rack enclosure. This NetServer is not supported in any other non-HP rack enclosure. • If you choose to use a door on this enclosure, only a Compaq model 4000or 7000-series door may be used. No other door may be used. The enclosure may then be used with the door open, closed, or removed. • Mass storage devices listed in the Tested Products List (located on the HP NetServer Navigator CD-ROM) are used exclusively in the NetServer. • Use HP rack accessories. (Note that HP rack accessories are not optimized for Compaq rack enclosures.) Compaq rack accessories have not been tested with HP NetServer products, but components such as monitors, keyboards, switchboxes, and PDUs often work. • Use APC® uninterruptible power supplies (UPS) with HP NetServers. APC offers mounting kits for Compaq rack enclosures. 1