HP LH4r HP Netserver LC 2000 Compaq Rack Install Guide - Page 26
See
 |
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 3 Rack-Mounting the HP NetServer WARNING The HP NetServer weighs 80 lbs. (36 kg) fully loaded. To prevent an accident, use two people when placing the NetServer into the rack. Mounting Tabs Stabilizing Feet Figure 3-11. Pulling Out the Slides 3. Pull out both slides until the slide members are fully extended. See Figure 3-11. The slides click into position when locked. This locked position prevents the slides from moving back into the rack, unless the release latches are pressed as shown in Figure 3-13. 4. Lift the HP NetServer by its four handles off the floor. 5. Move the rear of the NetServer just beyond the extended slide members. 22
-
1 -
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21 -
22 -
23 -
24 -
25 -
26 -
27 -
28 -
29 -
30 -
31 -
32
-
33
-
34
-
35
-
36
-
37
 |
 |
Chapter 3
Rack-Mounting the HP NetServer
22
WARNING
The HP NetServer weighs 80 lbs. (36 kg) fully loaded. To
prevent an accident, use two people when placing the
NetServer into the rack.
Mounting Tabs
Stabilizing Feet
Figure 3-11. Pulling Out the Slides
3.
Pull out both slides until the slide members are fully extended.
See Figure 3-11.
The slides click into position when locked. This locked position prevents
the slides from moving back into the rack, unless the release latches are
pressed as shown in Figure 3-13.
4.
Lift the HP NetServer by its four handles off the floor.
5.
Move the rear of the NetServer just beyond the extended slide members.