HP LH4r HP Netserver LC 2000 Compaq Rack Install Guide - Page 19
Attaching the Column Adapters and Slides
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Chapter 3 Rack-Mounting the HP NetServer "#" represents the EIA unit numbers on the rack columns. # # # # # 9th Hole From Bottom 7th Hole From Bottom Bottom of Compaq Rack Figure 3-4. Cage Nut Locations on the Rack's Rear Columns Attaching the Column Adapters and Slides 1. Make sure that anti-tip precautions have been taken before installing servers in the rack. 2. Align the right column adapter to the right front column. 3. Match the column adapter holes (2nd & 14th) to the marks on the front column and place the column adapter mounting holes behind the column face. See Figure 3-5. 4. With the column adapter held in position, insert the two screws with the large washer (included in the non HP rack-mount kit) through the holes in the column into the captive nuts on the column adapter. See Figure 3-5. 5. Repeat Steps 2 through 4 for the column adapter on the left front column. 15