HP LH4r HP Netserver LC 2000 Compaq Rack Install Guide - Page 31
HP NetServer LC 2000r Rack Cabling Reference, Guide
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Chapter 3 Rear of HP NetServer Left Rear Rack Column Rack-Mounting the HP NetServer Cable Management Arm Figure 3-16. Attaching the Cable Management Arm 5. Attach the other flange of the cable arm to the rear column of the rack with the two M6 screws, included with the non-HP rack kit. 6. Attach the flange to the NetServer with the two 2-32 pan head Torx T-20 screws, included with the Arm. See Figure 3-16. 7. Extend the NetServer out of the rack to ensure the Cable Management Arm moves along with the chassis without binding. NOTE Refer to the HP NetServer LC 2000r Rack Cabling Reference Guide, for information about cable dressing and routing. 8. If the Cable Management Arm moves with the chassis and the rack installation appears to be successful, slide the NetServer into the rack. The NetServer should click into the latches on the two column adapters. 9. If the NetServer is not in a restricted-access area, tighten both slide securing screws on the bezel latching mechanisms. See Figure 3-16. 27