HP LH4r HP Netserver LC 2000 Compaq Rack Install Guide - Page 25

Chapter 3 Rack-Mounting the HP NetServer Attaching the Mounting Handles Attach the four sheet metal mounting handles to the sides of the server. Each handle requires two Phillips head screws. See Figure 3-10. Figure 3-10. Attaching the Mounting Handles Placing the HP NetServer in the Rack Use this procedure to position the HP NetServer into the extended slides and secure the chassis to the slides. Once the NetServer is in the rack, then you connect the Cable Management Arm to the rear of the NetServer. WARNING To prevent rack instability while mounting the HP NetServer pull the rack's anti-tip foot forward out of the bottom. Failure to do so could result in injury and equipment damage. To prevent the rack from rolling while you mount the HP NetServer, ensure the leveler screws on the rack's lower four corners are in firm contact with the floor. See Figure 3-9. 1. Lower the leveler screws on the rack's lower four corners to make firm contact with the floor. See Figure 3-11. 2. Ensure you have extended the anti-tip foot from the rack, before continuing this procedure. See Figure 3-11. 21