HP LH4r HP Netserver LC 3 NetRAID-3Si Installation Guide - Page 5
HP NetServer LC3 with HP Rack Storage/12, Cluster Configuration Guide
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
HP NetServer LC3 with HP Rack Storage/12 Cluster Configuration Guide 20 January 2000 (see Version History at the end of this document) Introduction This document defines the supported HP NetServer LC3 configurations with HP Rack Storage/12s and Microsoft Cluster Server. These configurations minimize single points of failure (SPOF), provide maximum availability, and have been certified by Hewlett-Packard and Microsoft. This guide is prescriptive; it describes the configurations supported by HP. Any deviance to these configurations can result in an inoperative cluster or an operating cluster with degraded performance, hidden SPOFs, etc., and therefore will not be supported by HP. What's Defined Cluster SPUs Local and Shared Storage Intra-cluster and Client LANs Shared Storage Cabling Cluster Type of SPUs Number of nodes Shared Storage LANs: Client Intra-cluster Power source System software: Navigator version Operating System Service pack HP NetServer LC3 Each node must be the same model SPU, but may have different size main memory and cache. 2 HP Rack Storage/12 with HP NetRAID-3Si controller and HP disks. See Shared Storage below. Any NIC that is HP and Microsoft approved. See Client LAN below. HP D5013A/B with crossover cable. See Intra-cluster LAN below. Direct from power mains, power conditioner or uninterruptible power supply (UPS) using any power conditioner or UPS. L.16.05 or later Microsoft Windows NT Server 4.0, Enterprise Edition or later SP5 or later