HP LH4r HP Netserver LH Pro NetRAID Installation Guide - Page 18
Part 2: Setting Up the HP Storage System/6
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Part 2: Setting Up the HP Storage System/6 In this section, you prepare the HP Storage System/6 for cluster operations by: • Configuring the internal cabling on the HP Storage System/6 • Assigning SCSI IDs (via dip switches) for the disks in the HP Storage System/6 Verifying SS6 Internal Cabling Before connecting the disks housed in the HP Storage System/6, you need to setup the Storage System/6's internal cables to support the cluster. To gain access to internal cables and dip switches, you must open the storage system's side door. To remove the door from the HP Storage System/6: 1. Unlock the bezel from the chassis. 2. Pull the top of the bezel forward, swinging it down to clear the retaining clips at the bottom of the chassis. Lift the bezel away from the chassis, as shown in the following illustration. HP Storage System/6 Cabinet with Bezel and Side Cover Removed 3. Loosen the door-mounting screws using a flat-blade screwdriver. (The screws remain attached to the door.) HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997 9