HP LH4r HP Netserver LH Pro NetRAID Installation Guide - Page 26
Connecting the Cluster's Shared Storage
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Part 5: Installing HP NetRAID Software and Configuring the Disk Arrays Connecting the Cluster's Shared Storage Refer to one of the following schematics as you connect the HP Storage System/6 cabinet(s) to the cluster's NetServers. Use only D5957A NetRAID Cluster Adapters to connect the HP Storage System/6 to the servers. To connect the HP Storage System/6 unit(s) to the HP NetServers: 1. Power down all cluster hardware including both HP NetServers and the HP Storage System/6 cabinet(s) 2. Install the hot swap disks in the HP Storage System/6 cabinet(s). NOTE If you are using two HP Storage System/6 cabinets, proceed to steps 5 and 6 where you add cluster adapters for channel 1. Otherwise, proceed to "Connecting the LAN Adapters.". 3. Connect System A's NetRAID channel 0 to the SCSI A port located on the back of HP Storage System/6 #0. 4. Connect System B's NetRAID channel 0 to the SCSI B port located on the back of HP Storage System/6 #0. System A SCSI-B SCSI-A System B #0 SCSI-B SCSI-A SYSTEM DISK CD-ROM NetRAID Ch0 Ch1 External SS/6 A B SYSTEM DISK CD-ROM NetRAID Ch0 Ch1 HP NetServer LH Pro Cluster with One HP Storage System/6 5. Connect System A's NetRAID channel 1 to the SCSI A port located on the back of HP Storage System/6 #1. 6. Connect System B's NetRAID channel 1 to the SCSI B port located on the back of HP Storage System/6 #1. HP NetServer LH Pro Microsoft Cluster Installation Guide - 1 October 1997 17