HP LH4r HP Netserver LT 6000r Rack Cabling Guide - Page 24
Power Distribution Units
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
Chapter 2 Rack Cabling References Notes to Table 2-2. Note 1. For 100 VAC Systems, separately orderable cables and UPS are available from American Power Conversion Corporation (APC). Note 2. Consult American Power Conversion Corporation for model number of 100 VAC unit. Note 3. For 100 VAC, consult local electrical codes and order a PDU power cord with appropriate connector from American Power Conversion Corporation (APC). Note 4. Limit the 200 - 240 VAC, 10-amp PDU to 10 amps of capacity, plug it into the 200 - 240 VAC 16-amp PDU, and limit both together to 16 amps of capacity. Note 5. The CEE 7/7 cord is fused for 13-amp loads and limits the PDU to 13 amps of total supply. Note 6. The circuit load should be limited to the VA rating of the UPS when this switch is used. Power Distribution Units Three types of Power Distribution Units (PDU) are currently available for the LT 6000r, as follows: ◊ The 120 VAC PDU (HP product number E7675A) fits either horizontally between the columns of the rack or vertically along the outside edge of the vertical column. See Figure 2-3. This PDU is rated 16-amps unit with nine available NEMA 5-15R receptacles and one IEC 320 C13 fan receptacle. ◊ The wide-range 200/240 VAC PDU (HP product number E7671A) fits either horizontally between the columns of the rack or vertically along the outside edge of the vertical column. See Figure 2-3.This PDU is rated 16 amps and has six available C-13 receptacles and two C-19 receptacles. ◊ A wide-range 200/240 VAC, 10-amp extension (HP product number E7670A) can be plugged into the 16-amp unit to extend the number of C-13 receptacles by an additional 10. This accessory also allows positioning of receptacles at various levels in the rack. (To order the 16-amp unit with its 10-amp extension and jumper cable, order HP part number E7672A.) 20