HP LH4r HP Netserver LXr 8000 Memory Upgrade Guide - Page 27

Installing DIMMs on the Memory Board

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 27 highlights

6. Hold the memory board by the corners, and carefully pull the board from its slot until the edge connectors are free of the system board connectors. 7. Place the memory board component-side up on a firm, anti-static surface for protection. Installing DIMMs on the Memory Board Follow these steps to install a DIMM in a slot on the memory board. CAUTION Wear a grounded anti-static wrist strap connected to the NetServer chassis before installing DIMMs. Use only DIMMs acquired from HP. Contact HP Customer Support for a list of qualified DIMMs. HP will not support configurations that use non-HP EDO DIMMs. 1. With the board resting flat, component-side up, on a firm anti-static surface, orient it so that the edge connector faces left. 2. Remove a DIMM from its container, handling the module by its edges. Lay it on an anti-static surface. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
21
6.
Hold the memory board by the corners, and carefully pull the
board from its slot until the edge connectors are free of the system
board connectors.
7.
Place the memory board component-side up on a firm, anti-static
surface for protection.
Installing DIMMs on the Memory Board
Follow these steps to install a DIMM in a slot on the memory board.
CAUTION
Wear a grounded anti-static wrist strap connected to
the NetServer chassis before installing DIMMs.
Use only DIMMs acquired from HP. Contact HP
Customer Support for a list of qualified DIMMs. HP
will not support configurations that use non-HP EDO
DIMMs.
1.
With the board resting flat, component-side up, on a firm
anti-static surface, orient it so that the edge connector faces left.
2.
Remove a DIMM from its container, handling the module by its
edges. Lay it on an anti-static surface.