HP LH4r HP Netserver LXr 8000 Memory Upgrade Guide - Page 31
Replacing the Memory Board
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
CAUTION Close all retaining clips on the memory board before inserting it into your NetServer. This includes clips on empty slots as well as those on slots containing DIMMs. This facilitates insertion of the memory board. 9. Replace the memory board. See "Replacing the Memory Board." Replacing the Memory Board Once you have installed the DIMMs required for your desired configuration, do the following: 1. Locate the memory board slot. 2. Hold the memory board by its corners, with the component side down. Position it so the end with the connector points into the memory bay opening. 3. Insert the memory board into the guide rails on either side of the memory board slot. Slide the memory board into the memory board bay until it seats against the slot at the rear of the bay. See Figure 2-11. 25