HP LH4r HP Netserver LXr 8000 Memory Upgrade Guide - Page 29
Removing DIMMs From the Memory Board
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
CAUTION Do not rock the DIMM into place, but apply firm and even pressure. If a gap exists between the retaining clips and the DIMM module, remove the module and repeat steps 5-6. 7. Repeat steps 3 through 6 to install the other three DIMMs, according to the rules listed in "Memory Configuration Guidelines," until you have installed all DIMMs for your memory configuration. Removing DIMMs From the Memory Board CAUTION Wear a grounded anti-static wrist strap connected to the NetServer chassis before installing DIMMs. Follow these guidelines for removing DIMMs. • If reducing the number of DIMMs on the board, remove them only in increments of one full bank (four DIMMs). • When you finish removing DIMMs, the remaining DIMMs should be arranged on the board in one of the configurations shown in Figures 2-4 through 2-7. 23