HP LaserJet Enterprise MFP M633 Fax Guide - Page 20

Menu item

Description

Ring Frequency

2

Select the box beneath the

Ring Frequency

heading to open the keypad. Enter a value for

the ring frequency on the keypad, and then select the

OK

button. The default setting for

ring frequency is 68 Hz, which detects rings up to 68 Hz.

1

Ring Interval is a factory setting. Regulatory and ring-detect performance may be

affected

by changing this setting.

2

Use caution when changing Ring Frequency as some ring-detect features may be disabled when changing the default value.

FutureSmart 4

1.

From the Home screen on the printer control panel, select

Settings

.

2.

Open the following menus:

●

Fax

●

Fax Receive Settings

●

Fax Receive Setup

Configure

any of the following settings. Select

Done

when you are

finished.

Menu item

Description

Rings to Answer

The

Rings to Answer

setting determines the number of times the phone rings before the

call is answered by the fax accessory.

NOTE:

The default range for the available options for the

Rings to Answer

setting is

location

specific.

The range of possible

Rings to Answer

options is limited by location.

If the fax accessory is not answering, and the

Rings to Answer

setting is

1

, try increasing it

to

2

.

Ring Volume

Select the

Ring Volume

drop-down menu and adjust the ringer volume settings.

Fax Receive Speed

Select the

Fax Receive Speed

drop-down menu and select one of the following options:

●

Fast (v.34 – 33.6k)

●

Medium (v.17 – 14.4k)

●

Slow (v.29 – 9.6k)

NOTE:

Medium

is the default value.

14

Chapter 4

Change fax

configurations

ENWW

Section	Page
Overview	7
Introduction	7
HP MFP Analog Fax Accessory 700 features	8
Parts included with the fax accessory	8
Install the fax accessory	9
Install the fax accessory	9
Connect the fax accessory to a phone line	10
Verify fax operation	10
Update firmware	11
Set up fax	13
Introduction	13
Required fax settings	13
Set up fax by using the printer control panel	13
Change fax configurations	15
Introduction	15
Fax dialing settings	15
General fax send settings	17
Fax receive settings	19
Send a fax	21
Send a fax	21
Additional fax tasks	24
Improve fax image quality	25
Solve fax problems	27
Checklist for solving fax problems	28
What type of phone line are you using?	28
Are you using a surge-protection device?	29
Are you using a phone company voice-messaging service or an answering machine?	29
Does your phone line have a call-waiting feature?	29
Check fax accessory status	29
General fax problems	31
The fax failed to send	31
An Out of Memory status message displays on the printer control panel	31
Print quality of a photo is poor or prints as a gray box	31
You selected the Stop button to cancel a fax, but the fax was still sent	32
No fax address book button displays	32
Not able to locate the Fax settings in HP Web Jetadmin	32
The header is appended to the top of the page when the overlay option is enabled	32
A mix of names and numbers is in the recipients box	32
A one-page fax prints as two pages	32
A document stops in the document feeder in the middle of faxing	32
The volume for sounds coming from the fax accessory is too high or too low	32
Specifications	32
Fax accessory product specifications	33
Replacement parts and accessories	34

HP LaserJet Enterprise MFP M633 Fax Guide - Page 20

Settings, Fax Receive Settings, Fax Receive Setup

Page 20 highlights