HP Latex 3000 Users Guide - Page 413
Request to reinitialize the carriage, The Internal Print Server cannot detect the printer
View all HP Latex 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 413 highlights
Request to reinitialize the carriage In some cases you may be asked to reinitialize the carriage. This operation restarts some mechanical subsystems, avoiding the need to restart the whole printer. The Internal Print Server cannot detect the printer If the Internal Print Server cannot establish communication with the printer, without apparent reason of after modifying Windows properties, follow these steps: 1. Use the Wake up button in the Tools menu to try to reactivate the printer. 2. Turn off the printer's main switch, then turn it on again after 10 seconds and restart the built-in computer. 3. Check the cable connecting the built-in computer to the printer. 4. Check that the Internal Print Server is correctly set up. 5. Contact your service representative. Print Care spontaneously restarts The Print Care software may restart itself when it detects that the printer's firmware or the Internal Print Server or some of their components have been updated, so this can happen from time to time. Color calibration fails Automatic color calibration may fail occasionally. You may see the alert Color calibration cancelled because of scanning errors, which can be caused by various different problems. ● Reflective color measurements of the printed target cannot be performed reliably on the current substrate. Reflective color measurement can be unreliable or impossible on substrates that are non-white, transparent or translucent, very glossy, or have a very rough or punched surface. For these substrates, automated color calibration using the embedded spectrophotometer may not be possible. ● Some of the color measurements of the color calibration test chart are defective due to: - Stains or printhead crash marks on the substrate, that can be easily seen by visual inspection of the printed chart. Make sure the substrate has no stains before running color calibration. Printhead crash marks may occur when the substrate is wrinkled. See There are wrinkles and ink smears on the substrate on page 363. - Wrinkles or bubbles in the substrate, even when there has been no printhead crash. - Generally poor print quality (such as banding). See Troubleshoot print-quality issues on page 378. ● Either the embedded spectrophotometer or the line sensor is not working properly. If the problem persists, call your service representative (see HP Customer Care Centers on page 409). ENWW Request to reinitialize the carriage 407