HP Latex 3000 Users Guide - Page 87
Load a roll (roll-to-free-fall configuration), The printer is now ready to print.
View all HP Latex 3000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
16. Ensure that the spindle differentials are unlocked. 17. Use the Internal Print Server to lower the carriage beam to its printing position. 18. Go to the Internal Print Server and press the Finish button. The printer rotates the rolls to check their diameters, and it also checks the width of the roll, the winding direction, the vacuum, and the substrate advance calibration (this takes about a minute). NOTE: Some substrates (such as transparent substrates) cannot be measured by the printer in this way. In such cases, you will be asked to enter the Left Edge and Width fields yourself into the Internal Print Server. Use the ruler on the spindle to check these values. 19. An alert about substrate-advance tracking may appear at this point. For more information on when you might want to turn off automatic tracking, see Substrate-advance compensation on page 181. 20. For more information on when you might want to change the carriage beam position, see Substrate tips on page 39. The printer is now ready to print. Load a roll (roll-to-free-fall configuration) The substrate roll is mounted on the input spindle; the printed substrate will be deposited on the floor in front of the printer. The substrate goes from the input spindle (1) over the main roller (3), over the platen, over the front diverters (5) and then to the tension roller (7), after which it continues to the floor. ENWW Load a roll into the printer 81