HP Latex 850 HP Scitex LX850 & LX820 Printer: Installation Guide - Page 50

CAUTION, Make sure the quick connector is placed in the holding panel.

Get HP Latex 850 PDF manuals and user guides View all HP Latex 850 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 50 highlights

4. Press and hold the green button on the ISM side of the quick connector. 5. Partially insert the quick connector until both sides of the connection are perfectly aligned. 6. Release the green button on the ISM side of the quick connector and complete the coupling. You should hear a "click". CAUTION: Use only moderate force to make the connection. If it is difficult to make the connection, do not continue. Instead, start the process again. Using too much force could damage the internal fittings of the connectors or result in an incorrect color matching of the ink tubes. 7. Test the connection by gently pulling both connectors away from each other. 8. Make sure the quick connector is placed in the holding panel. 9. Press OK to start the purge. At this point, the printer sends ink to the carriage. This process takes approximately 5 minutes. 46 Chapter 7 Purge the ink system ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
4.
Press and hold the green button on the ISM side of the quick connector.
5.
Partially insert the quick connector until both sides of the connection are perfectly aligned.
6.
Release the green button on the ISM side of the quick connector and complete the coupling. You
should hear a "click".
CAUTION:
Use only moderate force to make the connection. If it is difficult to make the
connection, do not continue. Instead, start the process again. Using too much force could damage
the internal fittings of the connectors or result in an incorrect color matching of the ink tubes.
7.
Test the connection by gently pulling both connectors away from each other.
8.
Make sure the quick connector is placed in the holding panel.
9.
Press
OK
to start the purge.
At this point, the printer sends ink to the carriage. This process takes approximately 5 minutes.
46
Chapter 7
Purge the ink system
ENWW