HP Latex 850 HP Scitex LX850 & LX820 Printer: Installation Guide - Page 71
Install the covers, recommended to wear gloves when removing the covers.
![]() |
View all HP Latex 850 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Install the covers Manpower 1 person Tools T30 screwdriver Time 5 minutes NOTE: The covers are wrapped in plastic, and the screws are inside the packaging. It is recommended to install the covers last, in case of any issue that may require you to remove the covers. It is recommended to wear gloves when removing the covers. 1. On the left side, replace the six T30 screws that secure each cover. The position of the screws is the same on the rear cover as it is on the front cover. 2. On the right side, replace the four T30 screws that secure the rear cover. 3. On the right side, replace the four T30 screws that secure the sliding door, starting at the top. ENWW Install the covers 67
![](/manual_guide/products/hewlettpackard-scitex-lx850-hp-scitex-lx850-lx820-printer-installation-guide-6e455e6/71.png)
Install the covers
Manpower
Tools
Time
1 person
T30 screwdriver
5 minutes
NOTE:
The covers are wrapped in plastic, and the screws are inside the packaging. It is recommended
to install the covers last, in case of any issue that may require you to remove the covers. It is
recommended to wear gloves when removing the covers.
1.
On the left side, replace the six T30 screws that secure each cover. The position of the screws is
the same on the rear cover as it is on the front cover.
2.
On the right side, replace the four T30 screws that secure the rear cover.
3.
On the right side, replace the four T30 screws that secure the sliding door, starting at the top.
ENWW
Install the covers
67