HP Model 745 HP Model 745 Industrial Controller Owner's Guide - Page 101
Hardware Installation for Drives, Tools for Installation, T-10 or T-15 Torx driver
View all HP Model 745 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Installing and Configuring Mass Storage Devices Hardware Installation for Drives Table 7-1 Hardware Installation for Drives The following products are supported for mass storage in the Model 745. The mass storage module can hold up to five drives. All mass storage devices operate on the same single-ended narrow SCSI bus. There are two locations for a 5.25-inch device (one front facing and one rear facing) suitable for a removable media device or a fixed device. There are also two locations for a 3.5-inch device (one front facing and one rear facing) suitable for a removable media device or a fixed device. In addition, there is one location for a 3.5-inch fixed device. Included with the system are adapter brackets that allow mounting 3.5-inch devices in the 5.25-inch locations. Supported Mass Storage Devices Description 3.5-inch, 4 GB Single-Ended Disk 3.5-inch, 1.4 MB flexible disk drive 3.5-inch, DDS Tape Drive 5.25-inch, CD-ROM Drive Tools for Installation Before you start to install a new drive, make sure you have the following tools: No. 1 Pozidriv screwdriver T-10 or T-15 Torx driver Static-free work area 7-3