HP NetServer LXr Pro8 Installation Guide for Compaq Racks - Page 11
Installation
View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
3 Installation This section contains detailed instructions for installing an HP NetServer NetServer LH 3r, LH 4r, LH 3000r, or LH 6000r in the model 4000/7000 series of Compaq rack enclosures. Preparation Before beginning the installation of the NetServer into the rack, you must prepare the rack and the NetServer. Determine the location at which the NetServer is to be installed in the rack enclosure. Mark the bottom and top of this location on the rack columns. The HP NetServer measures 8 EIA units tall. Marking the Installation Holes Mark two holes on each of the four columns to use for the bar nuts and screws that hold the slides to the columns. When marking the holes, mark the outer surface of the column see Figure 3-1; on the front columns, this is the column surface facing forward; on the rear columns, this is the surface facing rearward. Use tape or a marker pen to mark the appropriate holes on each column. To mark the slide mounting holes refer to Figure 3-1: 1. Count up from the top of the unit below, marking the 20th and 22nd holes. 2. Repeat for all four columns. NOTE Do not place nuts or screws in the holes at this time, only mark them. 7