HP NetServer LXr Pro8 Installation Guide for Compaq Racks - Page 15
See
View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Chapter 3 Installation 2. Place the mounting flange of the slide between the inside of the column and the bar nut. See Figure 3-4. Do this at the front and rear of the slide. Push In and Up Figure 3-4. Mounting a Slide to a Column 3. If your slide has the dimple shown in Figure 3-3, center the dimple in the square hole on the rack column. 4. Press the slide firmly against the screws. Lift up against the screws. 5. While lifting the slide, tighten all four screws to secure the slide. NOTE It is very important to lift up on the slides prior to tightening the screws. Tightening the screws without lifting up on the slides will result in interference between the HP NetServer and other equipment in the rack; you may not be able to slide the HP NetServer into the rack enclosure after completing the installation. 6. Repeat for the other slide. 11