HP NetServer LXr Pro8 Installation Guide for Compaq Racks - Page 23

Relocating the Control Panel

Get HP NetServer LXr Pro8 PDF manuals and user guides View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

Chapter 3 Installation 2. Install the four screws that hold the tall, left-hand bracket to the face of the NetServer chassis and to the rack column see Figure 3-10. 3. Install the four screws that hold the short, right-hand bracket to the face of the NetServer chassis and to the rack column see Figure 3-10. Recessed Brackets Figure 3-10. Installing the Recessed Mounting Brackets Relocating the Control Panel The control panel and the control panel bezel must be relocated to fit the Compaq rack-compatible NetServer bezel. Relocate the control panel and its bezel, as follows: 1. Remove the control panel bezel from the NetServer by pressing in on the clips on either side of the bezel. 2. Unscrew the two screws securing the control panel to the chassis. 3. Unhook the control panel from the face of the chassis see Figure 3-11. A ribbon cable still connects it to the NetServer. 19

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Chapter 3
Installation
19
2.
Install the four screws that hold the tall, left-hand bracket to the face of the
NetServer chassis and to the rack column see Figure 3-10.
3.
Install the four screws that hold the short, right-hand bracket to the face of
the NetServer chassis and to the rack column see Figure 3-10.
Recessed Brackets
Figure 3-10.
Installing the Recessed Mounting Brackets
Relocating the Control Panel
The control panel and the control panel bezel must be relocated to fit the Compaq
rack-compatible NetServer bezel. Relocate the control panel and its bezel, as
follows:
1.
Remove the control panel bezel from the NetServer by pressing in on the
clips on either side of the bezel.
2.
Unscrew the two screws securing the control panel to the chassis.
3. Unhook the control panel from the face of the chassis see Figure 3-11. A
ribbon cable still connects it to the NetServer.