HP NetServer LXr Pro8 Installation Guide for Compaq Racks - Page 8
HP NetServer - Compaq Rack Precautions
View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Chapter 1 Introduction HP NetServer - Compaq Rack Precautions CAUTION If this NetServer is not installed according to these instructions, damage to the NetServer or accessories may result. Damage due to improper installation is not covered by the HP Warranty. Observe the precautions listed in this section to maintain the NetServer's reliability. When installing this HP NetServer in a Compaq rack enclosure, certain requirements must be addressed to assure that the needs of the NetServer are met. This NetServer will meet the requirements designed for the NetServer if: • The NetServer is installed in a Compaq model 4000- or 7000-series rack enclosure. This NetServer is not supported in any other non-HP rack enclosure. • If you choose to use a door on this enclosure, only a Compaq model 4000- or 7000-series door may be used. No other door may be used. The enclosure may then be used with the door open, closed, or removed. • If you install a cable management arm, be sure to remove and discard the rear door of the rack. • Mass storage devices listed in the Tested Products List (located on the HP NetServer Navigator CD-ROM) are used exclusively in the NetServer. • Use HP rack accessories. (Note that HP rack accessories are not optimized for Compaq rack enclosures.) Compaq rack accessories have not been tested with HP NetServer products, but components such as monitors, keyboards, switchboxes, and PDUs often work. • Use APC® uninterruptable power supplies (UPS) with HP NetServers. APC offers mounting kits for Compaq rack enclosures. This NetServer is not supported in a rack enclosure under circumstances other than those listed above. See the "Warranty and Support" section of this document for additional support considerations. 4