HP NetServer LXr Pro8 Installation Guide for Compaq Racks - Page 24

completely back inside the NetServer before mounting the control panel.

Get HP NetServer LXr Pro8 PDF manuals and user guides View all HP NetServer LXr Pro8 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 24 highlights

Chapter 3 Installation CAUTION Take care to not damage the ribbon cable that connects the control panel to the NetServer. 5. Reinstall the control panel in the leftmost slots, and install and tighten the screws. To avoid damaging the ribbon cable, verify that the ribbon cable goes completely back inside the NetServer before mounting the control panel. NOTE There are two possible locations for the control panel. Only the leftmost position is correct for Compaq rack installations. Mounting Slots for Compaq racks (on left) Mounting Slots for HP racks (on right) Control Panel Figure 3-11. Relocate the Control Panel 20

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
Chapter 3
Installation
20
CAUTION
Take care to not damage the ribbon cable that connects the
control panel to the NetServer.
5.
Reinstall the control panel in the leftmost slots, and install and tighten the
screws.
To avoid damaging the ribbon cable, verify that the ribbon cable goes
completely back inside the NetServer before mounting the control panel.
NOTE
There are two possible locations for the control panel. Only the
leftmost position is correct for Compaq rack installations.
Mounting Slots for Compaq racks (on left)
Control Panel
Mounting Slots for HP racks (on right)
Figure 3-11.
Relocate the Control Panel