HP OMEN 15-ce000 Maintenance and Service Guide - Page 71
Display assembly, Remove the display assembly
View all HP OMEN 15-ce000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 71 highlights
Display assembly IMPORTANT: Make special note of each screw and screw lock size and location during removal and replacement Before removing the display assembly, follow these steps: 1. Shut down the computer. 2. Disconnect all external devices connected to the computer. 3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then unplugging the AC adapter from the computer. 4. Remove the battery (see Battery on page 36), and then remove the following components: a. Hinge covers (see Hinge covers on page 45). b. System support brackets (see System support brackets on page 46). c. Fans (see Fans on page 49). d. Heat sink (see Heat sink on page 53). e. System board (see System board on page 58). Remove the display assembly: 1. Disconnect the display panel cable from the system board (1). 2. Disconnect the WLAN antenna cable from the system board (2). 3. Release the WLAN antenna cable from the clips securing it to the computer (3). 4. Open the computer with the bottom facing up (1). 5. Remove the four Phillips PM2.5×5.7 screws (2) securing the display assembly to the computer. Component replacement procedures 61