HP Officejet g85 HP OfficeJet G Series - (English) User Guide for Macintosh - Page 5

AvMac.book Page 1 Friday, June 23, 2000 10:34 AM 1 Additional setup information This section provides assistance in resolving installation and configuration issues, setting fax header information using the front panel, and adding and removing software. The standard installation instructions are provided in your Setup Poster, which you should retain for later use. Install your HP JetDirect Print Server Your OfficeJet G Series may be networked using the HP Jet Direct 300X Print Server. For the latest information regarding networking, visit the HP Web site at: www.hp.com/go/all-in-one Connect and configure the print server If you have already connected your HP OfficeJet to your Macintosh via the USB port, you must remove the USB cable and unplug the HP OfficeJet before setting up the Jet Direct Print Server. To connect and configure the print server 1 Using the instructions provided with the HP JetDirect Print Server and the 1284C cable provided with the OfficeJet, set up the hardware. NOTE Do not use the CD-ROM included in the print-server package. 2 Turn on the device and insert the HP OfficeJet G Series CD-ROM into your CD-ROM drive. 3 Locate and double-click on the HP Network Utility on the CD-ROM. 4 Select HP DeskWriter from the Select a drop-down list box. 5 Choose the HP OfficeJet G Series you want to install and click OK. 6 Select the Settings entry in the list on the left side. 7 Select TCP/IP in the Please select a setting: drop-down list box and click Edit. 8 Assign the IP number, subnet mask, and router address provided by your network administrator. Chapter 1—Additional setup information 1