HP Pavilion 8700 HP Pavilion PC's - PCTEL V.90/K56Flex Series AT Command Guide - Page 5

AT Command Guide L0 L1 L2 L3 M0 M1 M2 M3 N0 N1 O0 O1 Q0 Q1 Sn Sn=m Sn? V0 V1 W0 W1 W2 X0 X1 X2 X3 X4 Y0 Y1 Z0 Z1 =n ? Speaker volume zero Speaker volume low Speaker volume low Speaker volume low (Hardware currently limits volume adjustment to on/off) Speaker always off Speaker on until carrier detected Speaker always on Speaker on during answering only Disable auto-mode. This forces the modem to connect at the speed specified in register S37. Enable auto-mode. The modem will connect at the highest available line speed and ignore any ATBn command. Return to data mode. If you have entered the command mode using the time independent escape sequence, this will put you back in data mode without going on-hook. Retrain the modem. If the line condition has changed since the original connection, retraining the modem will cause it to reconnect at the most efficient speed for the current line condition. Enable response to DTE. Disable response to DTE. The modem does not send responses to the terminal. Issuing a command will not produce a response (unless the command is something like ATZ, which will restore this setting to default.) Set default S-register. Any subsequent = or ? commands will modify the default S register. Set register n to value m Return the value of register n Result codes will be sent in numeric form. (See the result code table) Result codes will be sent in word form. (See the result code table. Report DTE speed only. After connection, there will be no message about what Error Correction or Data Compression protocol is in use. Report DCE speed, Error Correction/Data Compression protocol, and DTE speed. Report DCE speed only Send OK, CONNECT, RING, NO CARRIER, ERROR and NO ANSWER. Busy and Dial Tone Detection is disabled. Send X0 messages and CONNECT speed Send X1 message and NO DIALTONE Send X2 messages and BUSY and RING BACK. Dial Tone Detection is disabled. Send all responses Disable long space disconnect Enable long space disconnect; with error correction, hang up after sending 1.6 second long space; without error correction, hang up after 4 second long space. Uses profile in & W0 Reset to configuration stored in profile 0 Uses profile in & W1 Reset to configuration stored in profile 1 Sets the value of the default S register Reports the value stored in the default S register. 5 V90K56DOCATC11A